Description
Palas MFP 3000 series filter test rigs have already proven themselves many times throughout the world in practical applications in development and quality control. The MFP 3000 filter test rig is a modular filter testing system for flat filter media and small mini-filters.
This system enables you to determine the:
- Pressure loss curve on the medium without a dust coating
- Fraction separation efficiency
- Burden and fraction separation efficiency during application of the burden
- The gravimetric separation efficiency within the shortest possible time, reliably and therefore cost-effectively.
The MFP 3000 operates in suction mode. This ensures a particularly uniform formation of the dust cake even at high inflow speeds. With the aid of the light scattering spectrometer (Palas Promo 3000), clear and reliable determination of the aerosol concentration and the particle size and therefore a clear determination of the fraction separation efficiency can be ensured. In addition, use of the Palas Welas digital 3000 or Palas Promo 3000 with two sensors for virtually simultaneous particle measurement offers the following advantages:
- Fully-automatic measurement of fraction separation efficiency
- Use of the testing system for very high and very low aerosol concentrations
The largely automated setup of the test sequence in conjunction with the clearly defined individual components and the individually adjustable sequence programs of the filter test software FT Control combine to deliver the high reliability of our measurement results.
Key Features
- Virtually simultaneous particle measurement in the raw gas and clean gas
- Particle size measurements from 200nm – 40µm
- Measurement particle concentration = 10 to the power of 6 particles/cm3 without dilution
- Internationally comparable measurement results
- Widespread distribution of the measurement system
- High reproducibility of the testing method
- Easy use of different test aerosols, e.g. SAE Fine and Coarse, NaCl , KCl, DEHS
- Highest raw gas concentrations of up to > 1000 mg/m3 (ISO Fine) or > 5000 mg/m3 (ISO Coarse) with measurement of the fraction separation efficiency for burden tests
- Flexible filter test software FT Control
- Sequence programs for pressure loss measurements, measurements of fraction separation efficiency and burden measurements
- Easy to operate, even untrained personnel can be instructed quickly in the use of the equipment
- Short set-up times
- Cleaning and calibration can be performed autonomously by the customer
- Easy use of the measurement technology components – even in other applications
- Mobile setup, easy to move on castors
- Reliable operation
- Validation of the clear function of individual components and the overall system during pre delivery acceptance testing and upon delivery
- Low-maintenance
- The unit will reduce your operating costs
Applications
- For filter media and small filter elements
- product development/ during production monitoring.
- Testing based on ISO 11155-1 / DIN 71460-1 (cabin air filters)
- Testing based on ISO 5011 (engine pre air filters)
- Testing based on ISO 16890 (room air filters)
- Other standards in various versions
- Fully automatic measurement of the fractional efficiency, the pressure drop curve, the dust holding capacity and the gravimetric efficiency
- International comparable results due to the high distribution of the system
System Variations
- MFP 3000 C – For testing filter media better than DIN 71460 and ISO 11155-1 road vehicle interior filters
- MFP 3000 FTD – With additional test duct for 400 cm² filter test area
- MFP 3000 G – Version for testing filter media better than EN 779 room air filters
- MFP 3000 HF – With active control of the relative humidity from 10 to 80 % and temperature from -10 to 50 °C
- MFP 3000 M – Version for testing filter media better than ISO 5011 / ISO TS 19713 engine air filters
